New generation comfort in toilet furniture

Easy DIY Installtion


INSTALLATION:

NUMO Toilet Arms are easy to install. If you have replaced a toilet seat, then you will find NUMO a breeze!


CONTENTS:

  1. Plastic coated steel base plate - one item
  2. Nylon reinforced plastic arms - two items
  3. Stainless steel bolts, nuts and washers - two pairs
install numo toilet arms Step 1

STEP ONE:

Slide the plastic arms over the base plate upstands. The arms may have to be tapped down into place to a position where the bottom screw hole aligns with the bottom hole of the base plate upstand.
install numo toilet arms Step 2

STEP TWO:

Insert the bolts making sure the countersunk heads are located to the inside of the arm and tighten nut over washer. Do not over tighten!
install numo toilet arms Step 3

STEP THREE:

Remove the existing toilet seat and place the NUMO base plate over the pan, using the two rear holes to align with the pan holes.
install numo toilet arms Step 4

STEP FOUR:

Locate the seat back over the base plate and pan securing the seat in the normal way with the nylon or metal fixing bolts supplied with the seat.

 

NOTE: Some older style seats have a skirt to the sides which may prevent the seat sitting down on the front of the pan with the NUMO Toilet Arm installation. You may choose to purchase a new seat (making sure it is flat on the underside) from your supermarket or hardware store.

CLEANING:

Use any good quality non-abrasive bathroom cleaner. Periodically remove the seat and NUMO Toilet Arms and clean between the base plate and pan.